Taping over varying ground profiles requires careful adaptation to achieve accurate measurements. On smooth, level ground with minimal vegetation, the tape can rest directly on the ground. Here, the taping team, typically consisting of a head and a rear tapeman, coordinates their positions with clear communication. The rear tapeman holds the tape at the starting point and guides the head tapeman toward a range pole placed beyond the endpoint, using hand or voice signals to ensure alignment.
On sloping, uneven terrain or in dense underbrush, however, the tape must be held horizontally to avoid ground interference. For precision, tapemen often use a plumb bob to align the tape correctly with ground points. In downhill situations, the breaking tape method is applied. The head tapeman holds the tape horizontally from an intermediate position and uses a plumb bob to mark specific points along the slope. A taping pin is set at each marked point, which the rear tapeman reaches and holds steady before passing it along the line.
This incremental approach, holding the tape horizontally in sections, minimizes errors caused by the uneven ground. By carefully aligning each section and marking points with accuracy, the team ensures consistent measurement integrity across varied terrains, maintaining precision from the starting point to the end of the tape line.
When taping on smooth, level ground with minimal underbrush, the tape can rest directly on the ground.
The taping team includes a head and rear tapeman. When the end of the tape reaches the rear tapeman, they call "tape" to stop the head tapeman.
The rear tapeman holds the end of the tape at the starting point and aligns the head tapeman using hand or voice signals to a range pole set beyond the endpoint.
On sloping, uneven ground or in dense underbrush, taping is done with the tape held horizontally, but one or both tapemen use a plumb bob for accuracy.
The breaking tape method is used while proceeding downhill. The head tapeman pulls the tape along the line and holds it horizontally from an intermediate point.
A plumb bob is aligned over a foot mark, and once the tape is stretched and leveled, the mark is set with a taping pin.
This mark is held until the rear tapeman arrives, then handed over at the foot mark.
This process is repeated, holding the tape horizontally in sections until reaching the zero end
繁體中文
